![]() it appears (when comparing with the synoloy config file) that i need to use "redirect-gateway def1". below is the text I have in my ovpn from wrt1900. ![]() As a result from some thinking i did (and some reading on various openvpn-pages), my think this behaviour (full tunnel vs split tunnel) is a setting in the config files my ovpn server provides to load onto my iphone app. I have been in contact with linksys for quite some time now, but apart from talking a lot to them about my current setup, I have not really made any progress. this connection DOES give me full tunneling, to be verified by the IP addy shown in (which is same as my ISP WAN side addy, as one would expect). an openvpn server on a synology nas in my lan. ![]() ![]() the wrt1900 server, this behaves as described abot I have ovpn configs for two servers I run I run the lastest version of OpenVPN connect on iphone 5. I want to use this in 'full tunnel' mode, meaning that ALL traffic i generate on my iphone, will be tunneled to my wrt1900, and from that point it must be routed into my lan or onto the internet.Ĭurrently, my I can reach my LAN ip addresses (so i do get tunnel/connection to my router), but traffic to the internet goes from my device straight onto internet and not through my wrt1900 ( shows the IP addy I got from 3G provider, even when connection is on). I have an openvpn server running on Linksys wrt1900ac router. I have an issue getting my OpenVPN to do what I want it.
0 Comments
Leave a Reply. |